G37 Coupe V6-3.7L (VQ37VHR) (2008)
/Page-947004.png)
2. Remove clips from pad pins.
3. Remove pad pins while holding down cross spring, then remove cross spring from caliper.
4. Using pliers, remove brake pads, shims and shim covers from caliper.
CAUTION:
^
Never damage the piston boot.
^
Never drop the brake pad, shims, and the shim cover.
INSTALLATION
WARNING:
Clean any dust from the brake caliper and brake pads with a vacuum dust collector. Never blow with compressed air.
CAUTION:
^
Never depress the brake pedal while removing the brake pads because the piston may pop out.
^
Never spill or splash brake fluid on the disc rotor.
1. Apply Copper based brake grease to the mating faces between the brake pads and shims, and install shims to the brake pad.
CAUTION:
^
Always replace the shims together when replacing the brake pad.
^
Never damage the piston boot.
^
In the case of replacing a pad with new one, check a brake fluid level in the reservoir tank because brake fluid returns to master
cylinder reservoir tank when pressing piston in.
2. Install upper pad pin from the inner side, then install firmly to the outer side through the hole in the top of brake pad.
