G37 Coupe V6-3.7L (VQ37VHR) (2008)
<---: Engine front
^
No. 1 cylinder at compression TDC
b. Rotate crankshaft 240° clockwise (when viewed from engine front) to align No. 3 cylinder at TDC its compression stroke.
NOTE:
Mark a position 240° (b) from a corner of the hexagonal part of crankshaft pulley mounting bolt as shown in the figure. Use the hexagonal part
as a guide.
1: Crankshaft pulley
A: Paint mark
^
By referring to the figure, measure the valve clearances at locations marked "x" as shown in the table below (locations indicated in the
figure).
<---: Engine front
^
No. 3 cylinder at compression TDC
c. Rotate crankshaft 240° clockwise (when viewed from engine front) to align No. 5 cylinder at TDC of compression stroke.
NOTE: