G37 Coupe V6-3.7L (VQ37VHR) (2008)
Accelerator Pedal Position Sensor: Service and Repair
ON-VEHICLE REPAIR
ACCELERATOR CONTROL SYSTEM
Exploded View
ACC-3 Exploded View
Removal and Installation
REMOVAL
1. Remove the cap and the inside mounting bolt.
2. Remove accelerator pedal assembly.
3. Disconnect accelerator pedal position sensor harness connector.
CAUTION:
-
Never disassemble accelerator lever. Never remove accelerator pedal position sensor from accelerator lever.
-
Avoid impact from dropping etc. during handling.
-
Be careful to keep accelerator lever away from water.
INSTALLATION
Installation is the reverse order of removal.
Inspection
INSPECTION AFTER INSTALLATION
-
Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released.
-
Check accelerator pedal securely returns to the fully released position.
-
For the electrical inspection of accelerator pedal position sensor, refer to EC-458, See: Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures/P Code Charts/P2122 "Description", EC-462, "Description" See: Testing and Inspection/Diagnostic Trouble Code Tests
and Associated Procedures/P Code Charts/P2127 and EC-466, "Description". See: Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures/P Code Charts/P2138
CAUTION: When harness connector of accelerator pedal position sensor is disconnected, perform Accelerator Pedal Released Position
Learning. Refer to EC-18, "ACCELERATOR PEDAL RELEASED POSITION LEARNING : Description". See: Testing and
Inspection/Programming and Relearning/Accelerator Pedal Released Position Learning