G37 Coupe V6-3.7L (VQ37VHR) (2008)
ASSEMBLY
1. Perform the spiral cable neutral adjustment as per the following procedure.
a. Rotate the spiral cable (1) clockwise (<---) slowly until it stops.
b. Rotate the spiral cable 2.5 turning counterclockwise (<---) slowly.
Align the spiral cable with the notch (A).
NOTE:
The spiral cable turns approximately 5 turning in maximum.
2. Install the 4WAS front actuator and the hole cover seal to the hole cover, and install the clamp to the hole cover.
CAUTION:
^
Assemble the clamp so as not to misalign the spiral cable position.
^
Never reuse the clamp.
3. Install the collar (1) to the 4WAS front actuator. Do not misalign the positions (A) and (B).
CAUTION:
Never damage the collar (1) and the hole cover (2).
4. Assemble the actuator harness to the hole cover.
5. Install the hole cover (lower) to the hole cover.
CAUTION: