G37 Coupe V6-3.7L (VQ37VHR) (2008)
RSU-17 Exploded View (Part 2)
Removal and Installation
REMOVAL
1. Remove tire with power tool.
2. Set suitable jack under axle assembly.
3. Remove mounting bolts and nuts in axle side of radius rod with power tool.
4. Remove mounting bolt in rear suspension member side of radius rod with power tool, then remove radius rod.
INSTALLATION
Note the following, and install in the reverse order of removal.
^
Perform final tightening of rear suspension member and axle installation position (rubber bushing), under unladen conditions with tires on level
ground.
Inspection
INSPECTION AFTER REMOVAL
Check radius rod and bushing for any deformation, cracks, or damage. Replace if there are.
INSPECTION AFTER INSTALLATION
^
Check wheel alignment. Refer to RSU-28, "Wheel Alignment". See: Alignment/Specifications/Rear Suspension/Wheel Alignment
^
Adjust neutral position of steering angle sensor after checking the wheel alignment. Refer to BRC-8, ADJUSTMENT OF STEERING ANGLE
SENSOR NEUTRAL POSITION: Special Repair Requirement".