G37 Coupe V6-3.7L (VQ37VHR) (2008)
12. Tighten rear extension assembly bolts to the specified torque.
1: Self-sealing bolt
A: Bolt
13. Install engine mounting insulator (rear).
14. Install rear engine mounting member.
15. Install control rod.
16. Install rear propeller shaft.
17. Install exhaust front tube and center muffler.
18. Install drain plug to oil pan. Tighten a necessary drain plug with specified torque. Refer to TM-232, "Exploded View". See: Valve Body/Service
and Repair/Control Valve with TCM
CAUTION:
Do not reuse drain plug gasket.
19. Pour ATF into A/T assembly.
Inspection
INSPECTION AFTER REMOVAL
If the contact surface on parking actuator support (1), parking pawl (2) and etc. has excessive wear, abrasion, bend, or any other damage, replace the
components.
INSPECTION AFTER INSTALLATION
Check the following item after completing installation.
^
A/T fluid leakage and A/T fluid level. Refer to TM-214, "Inspection". See: Service and Repair/Procedures
^
A/T position. Refer to TM-226, "Inspection and Adjustment". See: Shifter A/T/Testing and Inspection