G37 Coupe V6-3.7L (VQ37VHR) (2008)
PROPELLER SHAFT RUNOUT
^
Check propeller shaft runout at measuring points. If runout exceeds specifications, replace propeller shaft assembly. For measuring point, refer to
DLN-6, "Inspection". See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Rear Propeller Shaft: 3S80A
Limit
Propeller shaft runout: Refer to DLN-10, "Propeller Shaft Runout". See: Specifications/Rear Propeller Shaft: 3S80A/Propeller Shaft Runout
JOURNAL AXIAL PLAY
^
As shown in the figure, while fixing yoke on one side, check axial play of joint. If outside the standard, replace propeller shaft assembly.
Standard
Journal axial play: Refer to DLN-10, "Journal Axial Play". See: Specifications/Rear Propeller Shaft: 3S80A/Journal Axial Play
CAUTION:
Never disassemble joints.
CENTER BEARING
^
Check center bearing for noise and damage. If noise or damage is detected, replace propeller shaft assembly.
CAUTION:
Never disassemble center bearing.