G37 Coupe V6-3.7L (VQ37VHR) (2008)
Never damage the final drive companion flange and rubber coupling.
9. Remove center bearing mounting bracket fixing nuts.
CAUTION:
^
The angle (A), which the third axis rubber coupling (1) forms with the final drive companion flange (2), must be 5° or less.
^
Never damage the grease seal (3).
^
Never damage the rubber coupling.
10. Slide the propeller shaft in the vehicle forward direction slightly. Separate the propeller shaft from the final drive companion flange.
CAUTION:
^
The angle, which the third axis rubber coupling forms with the final drive companion flange, must be 5° or less.
^
Never damage the grease seal.
^
Never damage the rubber coupling.
11. Remove the propeller shaft assembly from the vehicle.
CAUTION:
Never damage the rear oil seal of transmission.
INSTALLATION
Note the following, and install in the reverse order of removal.
^
Install center bearing mounting bracket (Upper) (1) with its arrow mark (A) facing forward.
^
Adjust position of center bearing mounting bracket (1, 2) sliding back and forth to prevent play in thrust direction of center bearing insulator (3).
Install bracket to vehicle.