G37 Sedan V6-3.7L (VQ37VHR) (2010)
Check ATF Level
1. Park the vehicle on a lift.
2. Connect CONSULT III (C-III) to the vehicle.
3. Start the engine let it idle.
4. With C-III monitor ATF temperature.
5. Once the ATF temperature reaches approximately 104°F (40° C) shift the shift selector lever (shift lever) in each gear position.
^
Return the shift lever to the P (Park) position.
^
Set the parking brake.
^
Leave the engine idling.
NOTE:
ATF temperature must be maintained at 95-11 3°F (35-45°C) during ATF level check.
6. Raise the vehicle as level on the lift.
7. Remove the overflow plug from the transmission pan (see Figure 1).
^
Have a drain pan positioned under the overflow plug hole.
^
At first an initial amount of fluid may come out. Do not be concerned.
NOTE:
The engine should be idling the whole time during fluid level check.
8. Check for a steady drip.
^
If fluid has a steady drip perform Step 9 to complete ATF level check. If fluid does not drip out steadily skip Step 9 and go to Step 10.
9. Install a new overflow plug. This completes the ATF level check.
CAUTION:
Never reuse an overflow plug. Always use a new one with each ATF level check. Torque the filler plug to 12.4 N.m (1.3 kg-m 9 ft lb).