G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
Hood Latch: Service and Repair
Removal and Installation
HOOD
HOOD LOCK CONTROL : Removal and Installation
REMOVAL
1. Remove the washer tank. Refer to See: Wiper and Washer Systems/Windshield Washer Reservoir/Service and Repair/Removal And Installation.
2. Remove the radiator core support ornament.
-
Remove the radiator core support ornament mounting bolts and clips.
NOTE:
To remove the mounting bolts on both sides of radiator core support ornament, first remove the mounting bolts of front bumper
(shown by arrows in the figure) and pull up the bumper edge slightly to get working clearance.
CAUTION:
Never apply excessive force while pulling front bumper to prevent front bumper and front fender from being damaged.
-
Hold both sides of radiator core support ornament, pull it upwards and slide it rearwards of the vehicle.
-
Disconnect the harness clips and hood lock control cable clips on radiator core support.
3. Remove the fender protector (LH). Refer to See: Fender/Front Fender/Service and Repair/Removal and Installation.
4. Disconnect hood lock switch (RH side) harness connector.
5. Remove the hood lock bracket mounting bolts, and remove the hood lock bracket assembly. Refer to See: Radiator Support/Service and
Repair/Exploded View.
6. Remove the hood lock mounting bolts, and disassemble the hood lock from the hood lock bracket.