G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
7. Burnish contact surface between disc rotor and brake pads after refinishing or replacing disc rotor, or if a soft pedal occurs at very low mileage.
Refer to See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Rear Disc Brake.
Disassembly And Assembly
REAR DISC BRAKE
BRAKE CALIPER ASSEMBLY (2 PISTON TYPE) : Disassembly and Assembly
DISASSEMBLY
1. Remove brake pads.
CAUTION:
Never drop brake pad, shims, shim covers, pad pins and clips.
2. Remove caliper assembly.
3. Place a wooden block as shown in the figure, and blow air from union bolt mounting hole to remove pistons and piston boots and retaining rings.
CAUTION:
Never get fingers caught in the pistons.
4. Remove piston seal (1) from cylinder body using suitable tool.
CAUTION:
Be careful not to damage a cylinder inner wall.
ASSEMBLY
1. Apply brake fluid to piston seals (1), and install them to caliper.
CAUTION: