G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
3. If this bulletin applies and you have performed ECM reprogramming; when reprogramming is complete, the screen in Figure 2 appears.
4. Make sure to erase all DTCs from all Systems.
NOTE:
During reprogramming, DTCs will set in several systems. These DTCs must be erased from all systems.
5. Test drive the vehicle and make sure it operates correctly and the MIL (Check Engine light) is OFF.
^ If the Check Engine light comes ON, go back to ASIST for further diagnostic information. Refer to the applicable Electronic Service Manual as
needed.
^ Diagnosis and repairs beyond ECM reprogramming are not covered by this bulletin.
Disclaimer