G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
FRONT LOWER LINK
Removal and Installation
REMOVAL
1. Remove tire with power tool.
2. Set suitable jack under axle assembly to relieve the coil spring tension.
3. Remove front lower link mounting bolts and nuts (rear suspension member side).
4. Remove front lower link mounting bolts and nuts (axle housing side).
5. Remove front lower link.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
Perform final tightening of rear suspension member and axle installation position (rubber bushing), under unladen conditions with tires on level
ground.
Inspection
FRONT LOWER LINK
Inspection
INSPECTION AFTER REMOVAL
Check front lower link and bushing for any deformation, cracks, or damage. Replace if necessary.
INSPECTION AFTER INSTALLATION
-
Check wheel alignment. Refer to See: Alignment/Testing and Inspection.
-
Adjust neutral position of steering angle sensor. Refer to See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing
and Inspection/Programming and Relearning/Additional Service When Replacing Control Unit/Description See: Brakes and Traction
Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning/Additional Service When Replacing
Control Unit/Special Repair Requirement See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Programming and Relearning/Adjustment Of Steering Angle Sensor Neutral Position/Description See: Brakes and Traction
Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning/Adjustment Of Steering Angle Sensor
Neutral Position/Special Repair Requirement