G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
Clutch Pedal Assembly: Service and Repair
Removal and Replacement
CLUTCH PEDAL
Removal and Installation
REMOVAL
1. Remove kicking plate inner and dash side finisher. Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Body
Side Trim.
2. Remove instrument lower panel LH. Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal And Installation.
3. Remove bracket (1) and harness bracket (2).
4. Disconnect ASCD clutch switch and clutch interlock switch connectors and then remove clip of harness from clutch pedal assembly.
5. Remove snap pin and clevis pin.
6. Remove clutch pedal assembly.
7. Remove ASCD clutch switch, clutch interlock switch, and pedal pad.
8. Remove bushing using a suitable drift [Commercial service tool].
9. Remove stopper rubbers and pedal stopper rubber using a suitable remover.
INSTALLATION
Note the following, and install in the reverse order of removal.
Apply recommended grease to clevis pin and bushing.