G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
CAUTION:
Never damage gear carrier.
INSTALLATION
1. Apply multi-purpose grease to side oil seal lips.
2. Install side oil seal until it becomes flush with the case end, using the drift [SST: KV38100200 (J-26233)].
CAUTION:
-
Never reuse oil seal.
-
When installing, never incline oil seal.
3. Install side flange with the following procedure.
a. Attach the protector [SST: KV38107900 (J-39352)] to side oil seal.
b. After the side flange is inserted and the serrated part of side gear has engaged the serrated part of flange, remove the protector.
c. Put a suitable drift on the center of side flange, then drive it until sound changes.
NOTE:
When installation is completed, driving sound of the side flange turns into a sound that seems to affect the whole final drive.
d. Confirm that the dimension of the side flange (1) installation measurement (A) in the figure comes into the following.
Standard
A : 326 - 328 mm (12.83 - 12.91 in)
4. Install drive shaft. Refer to See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and Replacement/Rear Drive
Shaft/Exploded View.