G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
Seals and Gaskets: Service and Repair
Rear Final Drive R200V
Removal And Installation
SIDE OIL SEAL
M/T : Removal and Installation
REMOVAL
1. Remove center muffler with a power tool. Refer to See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair/Exploded View.
2. Remove rear wheel sensor. Refer to See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service
and Repair/Wheel Sensor/Exploded View.
3. Remove drive shaft from final drive with a power tool. Then suspend it by wire, etc. Refer to See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Drive Shaft/Exploded View.
4. Install attachment (A) [SST: KV40104100 ( -- )] to side flange, and then pull out the side flange with the sliding hammer
(B) [SST: ST36230000 (J-25840-A)].
NOTE:
Circular clip installation position: Final drive side
5. Remove side oil seal, using a flat-bladed screwdriver.
CAUTION:
Never damage gear carrier.
INSTALLATION
1. Apply multi-purpose grease to side oil seal lips.