I30 V6-2988cc 3.0L DOHC MFI (VQ30DE) (1997)
/Page-1501005.png)
Figure 6
12.
Position the control valve assembly on the transaxle ensuring the manual valve shaft correctly engages the manual plate (see Figure 5) and install
all mounting bolts in their original locations finger tight (see Figure 6). Then, using an appropriate torque wrench tighten all mounting bolts in a
criss-cross pattern to 7 - 9 Nm (61 - 78 in-lbs).
IMPORTANT:
The control valve assembly is secured with bolts of varying lengths. Make sure the bolts are re-installed in their original locations (see Figure
6).
13.
Route and install the solenoid valve assembly wire harness as follows:
A.
Clean the inside diameter surface of the transaxle hole that houses the harness terminal body.
B.
Inspect the harness terminal body O-ring for damage or outs. If damaged, replace the O-ring (O-ring P/N: 31526-31X12).
C.
Lubricate the harness terminal body O-ring with Nissan Matic-D ATF.
D.
Route the harness up through the transaxle terminal body hole until the terminal body is fully seated in its mating hole.
14.
Re-install the retaining clip to the harness terminal body.
15.
Clean the transaxle oil pan and remove all gasket material.
16.
Clean the sealing surface on the transaxle case and remove all gasket material.
17.
Re-install the oil pan with a new gasket to the transaxle using new mounting bolts. Tighten oil pan mounting bolts using an appropriate torque
wrench in a criss-cross pattern to 7 - 9 Nm (61 - 78 in-lbs).
18.
Install the transaxle in the vehicle.
19.
Check the transaxle ATF level and add Nissan Matic-D ATF as required.
