J30 V6-2960cc 3.0L DOHC (VG30DE) (1995)
Antenna: All Technical Service Bulletins
Power Antenna Rod Replacement
Classification: EL94-002a
Section: Electrical
Models: All Models
Reference:
TECHNICAL BULLETIN ITB94-014a
Date:
December 22, 1994
POWER ANTENNA ROD REPLACEMENT
This Bulletin contains revised Warranty information. Please discard the original.
APPLIED MODEL:
All
SERVICE INFORMATION
Improper retraction of the power antenna will usually be caused by a bent antenna rod. After ensuring that the antenna motor is receiving proper power
and in operational, replacement of the antenna rod is the only repair sequence needed to restore power antenna operation.
SERVICE PROCEDURE
Replacing The Antenna Rod
Antenna Mounting
1.
Remove antenna nut and base. (Figure 1)
2.
Turn the radio to "ON" and the antenna rod will extend*. Assist the antenna rod to fully separate from the antenna base. Note the direction of the
gear section On the antenna rope. (The new antenna rod must be installed in the same direction).
* If the antenna rod does not extend, always check the power supply to the power antenna before replacing the power antenna assembly.