J30 V6-2960cc 3.0L DOHC (VG30DE) (1995)
Fig. 37 Piston Skirt & "a" Dimension Measurements
Piston and Rod Assembly
1. Install new snap ring on one side of piston pin hole, heat piston to 140-158°F and assemble piston, pin connecting rod and snap ring.
2. Align direction of piston and connecting rod. Ensure numbers stamped on connecting rod and cap correspond to each cylinder, Fig. 35.
3. Refer to Fig. 36 and 37 for piston skirt measurements.
4. After assembling, ensure piston swings freely.
5. Set piston rings as shown in Fig. 38.