J30 V6-2960cc 3.0L DOHC (VG30DE) (1995)
3.
Remove the lower "B" pillar finisher by pulling it straight out from the top, then lifting it out past the seat belt (Figure 1).
NOTE:
If any of the white plastic clips for the finisher remain in the "B" pillar, remove them and install onto the finisher. If the white plastic clips are
damaged, replace them using P/N 01553-07381 (Figure 2). The part number for the two metal clips is 76988-60U00.
NOTE:
If the foam block on the rear of the "B" pillar lower finisher is loose, or has fallen off, it may be discarded. For more information, please see
Infiniti Service Bulletin ITB95-012a/BT95-002a, dated April 19, 1995, entitled "J30 Loose "B" Pillar Lower Finisher Repair Procedure."
4.
Pull out from the top the plastic cover above the seat belt reel assembly. Position the cover below the opening (Figure 3).
NOTE:
The LH plastic cover is gray in color. The RH plastic cover is semi-transparent.