J30t V6-2960cc 3.0L DOHC MFI (VG30DE) (1997)
DISASSEMBLY
1. Push out piston with piston boot with compressed air.
WARNING: DO NOT PLACE YOUR FINGERS IN FRONT OF PISTON.
CAUTION: Do not scratch or score cylinder wall.
2. Remove piston seal with a suitable tool.
INSPECTION
Cylinder Body
Check inside surface of cylinder for score, rust, wear, damage or presence of foreign objects. If any of the above conditions are observed, replace
cylinder body. Minor damage from rust or foreign objects may be eliminated by polishing surface with a fine emery paper. Replace cylinder body
if necessary.
NOTE: Use brake fluid to clean. Never use mineral oil.
Piston
Check piston for score, rust, wear, damage or presence of foreign objects. Replace if any of the above conditions are observed.
CAUTION: Piston sliding surface is plated. Do not polish with emery paper even if rust or foreign objects are stuck to sliding surface.
Main Pin, Pin Bolt And Pin Boot
Check for wear, cracks, rust or other damage. Replace if any of these conditions are observed.
ASSEMBLY
1. Insert piston seal into groove on cylinder body.
2. With piston boot fitted to piston, insert piston boot into groove on cylinder body and install piston.
3. Properly secure piston boot.
INSTALLATION
1. Install brake hose to caliper securely.
2. Install all parts and secure all bolts.
3. Bleed air from the hydraulic system. See: Brake Bleeding/Service and Repair