infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Before VIN 50001|Page 8683 > < General Precautions|Page 8680
Page 1
background image

Air Bag(s) Arming and Disarming: Service and Repair
Before VIN 50001

AIR BAG DISARM

Turn ignition Off, then disconnect both battery cables.

CAUTION:  Wait at least 10 minutes after disconnecting the ground cable before performing any service procedures. The Supplemental Restraint
System (SRS) is designed to retain enough voltage to deploy the air bag for a short time even after the cables has been disconnected. Performing
service before the minimum 10 minute lapse may cause unwanted deployment and possible injury.

AIR BAG ARM

1. Turn ignition Off, ensure nobody is inside vehicle, then connect battery cables.
2. Turn ignition On and note air bag warning lamp operation, which should light for approximately seven seconds, then go off.
3. If lamp remains On, does not light, or continues to flash, there is an SRS fault. Refer to Air Bags (Supplemental Restraint Systems) for System

Diagnosis and Testing.

Before VIN 50001|Page 8683 > < General Precautions|Page 8680