J30t V6-2960cc 3.0L DOHC MFI (VG30DE) (1997)
3. Remove grease seal.
4. Remove snap ring.
5. Press out bearing and race as a set.
INSPECTION
Wheel Bearing
-
Check wheel bearing to see that it rolls freely and is free from noise, crack, pitting, or wear, and replace if damaged.
Wheel Hub
-
Check wheel hub for crack by a magnetic exploration or dyeing test, and replace if cracked.
Knuckle Spindle
-
Check knuckle spindle for deformation, tapping mark, or cracks (by magnetic or dyeing test) and replace if damaged.
INSTALLATION
1. Press new wheel bearing assembly into wheel hub.
CAUTION:
-
Maximum load P: 29 kN (3 ton, 3.3 US ton).
-
Do not press inner race of wheel bearing assembly.
-
Do not apply oil or grease to mating surfaces of wheel bearing outer race and wheel hub.