M35 V6-3.5L (VQ35HR) (2009)
-
Apply new engine oil to both oil seal lip (A) and dust seal lip
(B).
-
Install it so that each seal lip is oriented as shown in the figure.
-
Using suitable drift [outer diameter: 60 mm (2.36 in)] (A), press-fit oil seal until it becomes flush with front timing chain case end face.
-
Check the garter spring is in position and seal lip is not inverted.
5. Install front timing chain case as follows:
a. Apply a continuous bead of liquid gasket with tube presser
(commercial service tool) to front timing chain case back side as shown in the figure.
Use Genuine RTV Silicone Sealant or equivalent. Refer to See: Specifications/Fluid Type Specifications/Recommended Chemical Products
and Sealants.
NOTE:
Apply liquid gasket, start and end up application at the portions