M35x AWD V6-3.5L (VQ35DE) (2007)
Clockspring Assembly / Spiral Cable: Service and Repair
SPIRAL CABLE
Exploded View SRS-44
Removal and Installation
REMOVAL
CAUTION:
-
Before servicing, turn ignition switch OFF, disconnect both battery terminal and wait at least 3 minutes.
-
Do not use air tools or electric tools for servicing.
-
Do not disassemble the spiral cable.
-
Do not allow oil, grease, detergent or water to come in contact with the spiral cable.
-
Do not make an impact to the spiral cable by dropping etc. Replace the spiral cable if it has been dropped or sustained an impact.
1. Remove the air bag module.
2. Remove the steering wheel.
3. Remove the column cover.
4. Remove the wiper washer switch, then remove light and turn signal switch from the spiral cable.
5. Remove the spiral cable.
-
Disconnect the horn switch connector (shown as A in the figure).
-
Disconnect the spiral cable connector (shown as B in the figure).
-
Loosen the spiral cable fixing screws.
-
Shift the spiral cable forward a bit while pushing the pawl located above the spiral cable.
-
Disconnect the steering wheel switch connector (shown as C in the figure).