M35x AWD V6-3.5L (VQ35DE) (2007)
Seat Belt Retractor: Service and Repair
Front
REMOVAL OF SEAT BELT RETRACTOR
1. Remove the outer anchor.
-
Remove the belt tension sensor cover and cover protector (passenger side only).
-
Disconnect the belt tension sensor connector (passenger side only).
-
Remove the fixing bolt of the outer anchor.
2. Remove the shoulder anchor.
-
Remove the center pillar lower and upper garnishes, refer to "BODY SIDE TRIM".
-
Remove the fixing anchor nut of the shoulder anchor.
3. Remove the seat belt assembly.
-
Disconnect the seat belt pre-tensioner connector.
CAUTION:
-
For installing/removing seat belt pre-tensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove
connector.
-
Install connector with lock raised, and push lock into connector.
-
Disconnect the pre-crush seat belt connector (for only the vehicle with pre-clash seat belt).
-
Remove the fixing screw and anchor bolt of the pre-tensioner seat belt retractor.
INSTALLATION OF SEAT BELT RETRACTOR
-
Install in the reverse order of removal.
-
Tighten by specified torque.
Tightening torque: 49.0 N.m (5.0 kg-m, 36 ft-lb)