M35x AWD V6-3.5L (VQ35DE) (2007)
Impact Sensor: Service and Repair
Crash Zone Sensor
CRASH ZONE SENSOR
Removal and Installation
REMOVAL
CAUTION:
-
Before servicing, turn ignition switch OFF, disconnect both battery terminal and wait at least 3 minutes.
-
Do not use air tools or electric tools for servicing.
-
Do not use old fixing nuts after removal; replace with new nuts.
-
Do not make an impact to the crash zone sensor by dropping etc. Replace the crash zone sensor if it has been dropped or sustained an
impact.
-
Replace the crash zone sensor of deployed SRS driver air bag and deployed SRS front passenger air bag.
1. Remove the crash zone sensor.
-
Remove the front grille.
-
Remove the crash zone sensor fixing nuts.
Fixing nut : 10.8 N.m (1.1 kg-m, 8 ft-lb)
-
Disconnect the crash zone sensor harness connector.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Be careful not to damage the crash zone sensor harness.
-
After the work is completed, make sure no system malfunction is detected by air bag warning lamp.
-
In case that malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by
CONSULT-II.
-
In case that malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions. Refer to SRS-20, "SRS
Operation Check". See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures/Manufacturer Code Charts/Air Bag System/SRS Operation Check