M35x AWD V6-3.5L (VQ35HR) (2010)
Vacuum Brake Booster: Procedures
BRAKE BOOSTER
On-Board Inspection and Service
OPERATION CHECK
With engine stopped, change vacuum to atmospheric pressure by depressing brake pedal several times. Then with brake pedal fully depressed, start
engine and when vacuum pressure reaches the standard, make sure that clearance between brake pedal and floor panel decreases.
AIR TIGHT CHECK
-
Run engine at idle for approximately 1 minute, and stop it after applying vacuum to booster. Depress brake pedal normally to change vacuum to
atmospheric pressure. Make sure that distance at intervals of 5 seconds between brake pedal and floor panel gradually increases.
-
Depress brake pedal while engine is running, and stop engine with pedal depressed. The pedal stroke should not change after holding pedal down
for 30 seconds.