M37 V6-3.7L (VQ37VHR) (2011)
Collision Avoidance Module: Technical Service Bulletins
Collision Avoidance - Blind Spot Intervention Activation
Date: July 8, 2010
2011 M37/M56 AND QX56;
BLIND SPOT WARNING / BLIND SPOT INTERVENTION ACTIVATION AT PDI
This bulletin has been amended. The APPLIED VEHICLES section has been revised and additional photos have been applied to the Service Procedure.
No other changes have been mlade. Please discard all previous copies.
2011 M37/M56 (Y51)
2011 QX56 (Z62)
^ As an option:
2011 QX56 vehicles may be equipped with the Blind Spot Warning (BSW) system.
2011 M37/M56 vehicles may be equipped with the Blind Spot Warning (BSW) and Blind Spot Intervention (BSI) systems.
^ Vehicles equipped with the BSW / BSW & BSI system(s) are shipped from the factory with the system(s) inactive (non functional).
^ If equipped, the BSW / BSW & BSI system(s) must be activated at PDI.
^ Use the procedure in this bulletin to activate the BSW / BSW & BSI system(s) during the PDI procedure.
^ The Flat Rate Time for 2011 M37/M56 and 2011 QX56 PDI includes time for performing the BSW / BSW & BSI activation. The BSW / BSW & BSI
initial activation is not a warrantable expense.
1. Turn ON the ignition with the engine OFF (not running).
2. Turn ON the right side turn signal.
3. Wait for the BSW / BSW & BSI indicator light to start flashing.
^ The indicator light should start flashing approximately seven (7) seconds after turning ON the ignition.
4. Push the Warning System Switch six (6) times.