M45x AWD V8-4.5L (VK45DE) (2008)
Brake Master Cylinder: Removal and Replacement
Removal and Installation
BR-15 COMPONENTS
CAUTION:
^
Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away
with water immediately.
^
Never scratch the piston of master cylinder when installing/removing because the piston is exposed. Check if any dust is not on the piston,
and wash with brake fluid if needed.
^
Hold cylinder body when handing master cylinder. Never hold the piston because the piston might be detached if pulled strongly.
REMOVAL
1. Drain brake fluid.
2. Disconnect brake fluid level switch harness connector.
3. Disconnect master cylinder brake tubes, using a flare nut wrench.
4. Remove master cylinder mounting nuts and remove master cylinder assembly from vehicle.
INSTALLATION
CAUTION:
^
Refill with new brake fluid "DOT 3".
^
Never reuse drained brake fluid.
1. Installation is in the reverse order of removal.