M45x AWD V8-4.5L (VK45DE) (2008)
CLAIMS INFORMATION
SERVICE PROCEDURE
1.
Remove one of the rear axles (driveshafts).
^
Refer to section RAX in the Service Manual for the driveshaft removal information.
IMPORTANT:
Make sure to mark the driveshaft and hub as shown in Figure 1 before removing the driveshaft.
^
Put a mark on the end of the driveshaft and a matching mark on the hub as shown in Figure 1.
NOTE:
These marks will be used when reinstalling the driveshaft.
2.
Collect 1.2 - 4.0g of Molykote M77 grease.
^
This is the amount for one axle.