Q45 V8-4.5L (VK45DE) (2002)
Lower Side Moulding / Trim: Service and Repair
Side Guard Molding
REMOVAL
1. Apply masking tape around outer circumference of side guard molding.
2. Remove double-sided adhesive tapes with (wide) resin spatula. Disconnect clips and remove side guard molding.
INSTALLATION
1. Remove double-sided adhesive tape remaining on vehicle.
2. Clean contact surface of vehicle (to side guard molding), and install side guard molding to vehicle.
-
To re-use side guard molding, follow above steps 1 and 2 as well; clean surface after removing double-sided adhesive tape, apply new
double-sided adhesive tape as shown in illustration, then install side guard molding to vehicle.
CAUTION:
-
Do not let air between contact surfaces when installing.
-
To secure contact, do not wash vehicle within 24 hours after installation.