Q45 V8-4.5L (VK45DE) (2002)
Vehicle Test Drive
Test drive the vehicle with 1/8 throttle application (engine RPM less than 2000). The transmission should upshift through gears 1-2, 2-3, 3-4 and 4-5.
PARTS INFORMATION
CLAIMS INFORMATION
Transmission Control Module (TCM) Reprogramming
SERVICE PROCEDURE
TCM Reprogramming involves three general steps
^
Download the TCM Reprogramming data from ASIST to CONSULT-II
^
Use CONSULT-II (with Reprogramming Card) to install the TCM Reprogramming data into the vehicle
^
Use CONSULT-II (with Diagnostics card) to "Initialize" the vehicle's TCM
Download TCM Reprogramming data from ASIST to CONSULT-II
1.
Install the ECU Reprogramming Software Card (orange) into slot A of CONSULT-II.
2a.
Connect the AC power supply to CONSULT-II.
2b.
Connect CONSULT-II to the ASIST PC with the special Ethernet cable (P/N 02002554, printed on the cable) contained in the CONSULT-II kit.
^
Connect the special Ethernet cable to CONSULT-II at the "PC port" located at the bottom end of the CONSULT-II unit
^
Connect the special Ethernet cable to the ASIST PC by connecting it to the "Ethernet card" connection port located on the back of the
computer
NOTE:
DO NOT USE the network cable attached to the Infinitinet network.
3.
Confirm the CONSULT-II date and time is correctly set as follows:
A.
With the ECU Reprogramming Software card in slot 1, turn on CONSULT-II.
B.
Touch "Sub Mode".
C.
Touch "Set Date".
^
If date is not correct, touch the month, day or year as needed. Then adjust it by using arrow keys. Once done, press "Save", press "Back"
and go to step D.