QX4 V6-3275cc 33L SOHC MFI (VG33E) (1998) | EGR Control Solenoid | Diagrams | Page 6349
CONNECTOR AND TERMINAL PIN KIT
Use the connector and terminal pin kit listed below when replacing connectors or terminals.
The connector and terminal pin kit contains some of the most commonly used INFINITI connectors and terminals.
BEHIND INSTRUMENT PANEL
Improperly routed or improperly clamped harness can become pinched during accessory installation. Vehicle vibration can aggravate a harness which is
routed along a bracket or near a screw behind or below the dash.
COLD OR HOT START UP
Electrical Load Test
On some occasions an electrical incident may occur only when the car is started cold. Or it may occur when the car is restarted hot shortly after being
turned OFF. In these cases you may have to keep the car overnight to make a proper diagnosis.
ELECTRICAL LOAD
The incident may be electrical load sensitive. Perform diagnosis with all accessories (including A/C, rear window defogger, radio, fog lamps) turned on.
ENGINE COMPARTMENT
There are several reasons a vehicle or engine vibration could cause an electrical complaint. Some of the things to check for are:
A. Connectors which are inaccessible for diagnosis probing.
B. Connectors which may not fully be seated.
C. Wiring harness which are not long enough and are being stressed during engine vibrations or rocking.
D. Wires laying across brackets or moving components.
E. Loose, dirty or corroded ground wires.