QX4 2WD V6-3.5L (VQ35DE) (2003)
2.
Remove the screws securing the OHM to the vehicle (see Figure 10).
3.
Check the connectors on the back of the OHM (see Figure 11).
4.
Secure cable leads to back of OHM with duct tape to prevent harness pinching.
Install the OHM using the machine screws and lock washers removed in step 2, (Torque 20 - 22 in-lb. or 2.3 - 2.5 Nm).
CAUTION:
DO NOT use power tools here. Only hand-tighten the machine screws. This will prevent stripping the screw threads.
CAUTION:
Be sure OHM connector cables and body gasket are positioned correctly to avoid pinching.