QX4 2WD V6-3.5L (VQ35DE) (2003)
6. Touch "WORK SUPPORT "
7. Touch "LASER BEAM ADJUST".
8. Touch "START".
CAUTION: If the adjustment screen does not appear on CONSULT-II 10 sec. after touching "LASER BEAM ADJUST" screen, the following causes
may be considered:
*
Target is not set accurately.
*
There is not enough space beside the target.
*
Deformation of vehicle or the surrounding equipment unit, bracket, or the surrounding equipment is causing inappropriate installation
of sensor and aiming may be set out of the adjustable range.
*
The area is not suitable for the adjustment work.
*
ICC sensor is not clean.
*
Laser beam adjustment may not be processed if something interrupts the laser beam.
9. After the CONSULT-II displays "ADJUST THE VERTICAL OF LASER" turn the up-down direction adjustment screw until "U/D CORRECT"