QX4 2WD V6-3.5L (VQ35DE) (2003)
value is set in the range of ±4.
CAUTION: Turn the screw slowly. The value change on display is slower than actual movement of the ICC sensor. Wait for 2 seconds every time the
screw is turned half a rotation.
NOTE: Turning the screw to the right lifts the aiming and to the left lowers the aiming.
10. When "U/D CORRECT" value indicates ±4, confirm that the margin of value remains within ±4 at least for 2 seconds with no equipment or hand
touching the ICC sensor. When "COMPLETED THE VERTICAL AIMING OF LASER BEAM" appears on screen, touch "END".
CAUTION: Be sure that the margin of "U/D CORRECT" is within ±4 with ICC sensor unit is untouched.
11. Confirm that "ADJUSTING AUTOMATIC HORIZONTAL LASER BEAM AIMING "is on screen and wait for a while (maximum: 10 sec.).
12. Confirm that "NORMALLY COMPLETED" is displayed on CONSULT-II and close the aiming adjustment procedure by touching "END".
CAUTION: Complete all the procedures once "LASER BEAM ADJUST" mode is entered in CONSULT-II. When the procedure is discontinued, the