QX4 2WD V6-3.5L (VQ35DE) (2003)
Accelerator Pedal: Service and Repair
Removal and Installation
CAUTION:
-
Accelerator wire should be adjusted when removing and replacing any parts of accelerator control system, shown in the figure.
-
Check that throttle valve opens fully when accelerator pedal is fully depressed. Also check that it returns to idle position when pedal is released.
-
Check accelerator control parts for improper contact with any adjacent parts.
-
When connecting accelerator wire, be careful not to twist or scratch its inner wire.
-
Refer to, "AUTOMATIC SPEED CONTROL DEVICE" for ASCD wire adjustment. See: Cruise Control/Cruise Control Servo
Cable/Adjustments
Adjusting Accelerator Wire
1. Loosen lock nut.
2. Tighten accelerator adjusting nut until throttle drum starts to move.
3. From that position, turn back adjusting nut 1.5 to 2 turns, and secure lock nut.