QX4 2WD V6-3.5L (VQ35DE) (2003)
Seat Belt Pre-Tensioner: Service and Repair
Deployment and Disposal
Checking Deployment Tool
Connecting to Battery
CAUTION: The battery must show voltage of 9.6V or more.
Remove the battery from the vehicle and place it on dry wood blocks approximately 5 m (16 ft) away from the vehicle.
-
Wait 3 minutes after the vehicle battery is disconnected before proceeding.
-
Connect red clip of deployment tool to battery positive terminal and black clip to negative terminal.
Make sure the polarity is correct. The right side lamp in the tool, marked deployment tool power , should glow with a green light. If the right side lamp
glows red, reverse the connections to the battery.
Air Bag Deployment Tool Lamp Illumination Chart (Battery Connected)
Deployment Tool Check
Press the deployment tool switch to the "ON" position. The left side lamp in the tool, marked "air bag connector voltage should illuminate. If it does not
illuminate, replace the tool.
Deployment of Air Bag and Seat Belt PreTensioner (In Vehicle)
Unless the vehicle is being scrapped, deploying the air bag in the vehicle is not recommended. This may cause damage to the vehicle interior.
When disposing of a vehicle, deploy air bag module and seat belt pre-tensioners while they are mounted in vehicle.