QX4 2WD V6-3.5L (VQ35DE) (2003)
![background image](/infiniti/qx4_2wd/v6-3.5l_(vq35de)/Page-212002.png)
PROBING FROM HARNESS SIDE
Standard type (not waterproof type) connector should be probed from harness side with "T" pin.
^
If the connector has a rear cover such as a ECM (Engine control Module) connector, remove the rear cover before probing the terminal.
^
Do not probe waterproof connector from harness side. Damage to the seal between wire and connector may result.
PROBING FROM TERMINAL SIDE
Female Terminals
^
There is a small notch above each female terminal. Probe each terminal with the "T" pin through the notch.
Do not insert any object other than the same type male terminal into female terminal.
^
Some connectors do not have a notch above each terminal. To probe each terminal, remove the connector retainer to make contact space for
probing
Male Terminals
Carefully probe the contact surface of each terminal using a "T" pin.
Do not bend terminal.
HOW TO CHECK ENLARGED CONTACT SPRING OF TERMINAL
An enlarged contact spring of a terminal may create intermittent signals in the circuit.
If the intermittent open circuit occurs, follow the procedure below to inspect for open wires and enlarged contact spring of female terminal.