QX56 V8-5.6L (VK56DE) (2004)
7. Touch "START".
CAUTION: If the adjustment screen does not appear on CONSULT-II 10 sec. after touching "LASER BEAM ADJUST" screen, the following
causes may be considered:
-
Target is not set accurately.
-
There is not enough space beside the target.
-
Deformation of vehicle or inappropriate installation of sensor. Sensor may be installed out of the adjustable range.
-
The area is not suitable for the adjustment work.
-
ICC sensor is not clean.
8. After the CONSULT-II displays "ADJUST THE VERTICAL OF LASER BEAM AIMING" turn the vertical adjusting screw until "U/D
CORRECT" value is set in the range of ± 4.
CAUTION: Turn the screw slowly. The value on the CONSULT-II is slower than the actual movement of the ICC sensor. Wait 2 seconds
between each adjustment.
NOTE: Turning the screw clockwise raises the ICC sensor and counterclockwise lowers the ICC sensor.