QX56 V8-5.6L (VK56DE) (2004)
CONSULT-II screen.
b.
CONSULT-II will automatically print out a report (see Figure 21).
^
Attach the print-out report to the Repair Order for future reference.
7.
Press [BACK] two times to return to the main menu.
8.
Turn the ignition switch OFF and CONSULT-II OFF.
9.
Continue with Section 5.
Section 5
Section 5:
Again, perform a check of all Systems in "SELF-DIAG RESULTS" and erase any newly stored DTCs.
1.
Remove the 8 MB orange Reprogramming Card from CONSULT-II.
2.
Install the red/white Diagnostic Card into Slot A (top slot) of CONSULT-II.
3.
Turn the ignition switch ON (do not start the engine).
^
CONSULT-II will turn ON automatically.
^
Confirm that all electrical loads* (except for the ignition) are OFF.
* Headlights defroster A/C audio (radio) video cellular telephone etc.
4.
Press [START (Nissan BASED VHCL)]
5.
In "SELF-DIAG RESULTS" check and erase any DTCs in the below noted vehicle systems:
IMPORTANT:
You MUST press "ERASE" and "OK" in all systems (shown below) whether a DTC is displayed or not. This is required to complete the VDC
reprogramming procedure, and it will make sure that all DTCs are erased.
^
ENGINE
^
A/T
^
ABS
^
AIR BAG
^
ALL MODE AWD/4WD (if applicable)
^
DIFF LOCK (if applicable; 4WD Titan)