QX56 AWD V8-5.6L (VK56DE) (2005)
4.
Mount a dial indicator so it contacts the rotor in the area where the brake caliper mounts as shown in Figure 1a.
Maximum runout when checking in this manner: 0.05 mm (0.002 in)
^
If runout is 0.05 mm (0.002 in) or less remove the wheel and tire and go to Step 4 (Clean and Inspect the Cylinder Body).
Runout must not be more than 0.05 mm (0.002 in)
Rotor Indexing
When installing a new rotor use the following indexing procedure. Indexing helps ensure a minimum amount of rotor runout ("lateral" or side-to-side
movement as it's rotating).
A.
Make sure the rotor is fully contacting the hub. Check the rotor-to-hub surface. Clean off all rust dirt or other debris.
NOTE:
For cleaning the hub surface specifically around the wheel studs it is recommended to use the Wheel Hub Cleaning Kit # J-42450-A which can
be ordered from Nissan TECH-MATE.
B.
Install the rotor and all lug nuts. Tighten the lug nuts to 40 ft-lbs (for this indexing process only).
^
Make sure you use open-ended lug nuts.