QX56 AWD V8-5.6L (VK56DE) (2005)
Disassembly and Assembly
Disassembly and Assembly of Brake Caliper Assembly
DISASSEMBLY
1. Remove sliding pin bolt, and then remove the pad, shim, shim cover, and pad retainer from the torque member.
2. Remove sliding pins and sliding pin boots from torque member.
3. Place a wooden block as shown, and blow air from union bolt mounting hole to remove pistons and piston boots.
CAUTION: Do not get your fingers caught in piston.
4. Using a flat-bladed screwdriver, remove piston seal from cylinder body.
CAUTION: Be careful not to damage cylinder body inner wall.
ASSEMBLY
CAUTION: Do not use NISSAN Rubber Grease (KRE00 00010, KRE00 00010 01) when assembling.
1. Apply clean brake fluid to new piston seal and insert seal in to groove on cylinder body.
CAUTION: Do not reuse piston seal.