QX56 AWD V8-5.6L (VK56DE) (2005)
5. Remove the chain tensioner on the left bank using the following steps.
WARNING: Plunger, spring, and spring seat pop out when squeezing return-proof clip without holding plunger head. It may cause
serious injuries. Always hold plunger head when removing.
a. Squeeze return-proof clip ends using suitable tool and push the plunger into the tensioner body.
b. Secure plunger using stopper pin. Stopper pin is made from hard wire approximately 1 mm (0.04 inches) in diameter.
c. Remove the bolts and the chain tensioner.
NOTE:
^
Stop plunger in the fully extended position using return-proof clip 1 if stopper pin is removed.
^
Push the plunger 2 into the tensioner body while squeezing the return-proof clip 1. Secure it using stopper pin 3.
6. Remove the right chain tensioner cover from the front cover using Tool.
Tool number : KV10111100 (J-37228)
CAUTION: Do not damage mating surfaces.
7. Remove chain tensioner on right bank using the following steps.
WARNING: Plunger, spring, and spring seat pop out when squeezing return-proof clip without holding plunger head. It may cause
serious injuries. Always hold plunger head when removing.