QX56 AWD V8-5.6L (VK56DE) (2005)
NOTE: Turning ignition switch off when performing CAN diagnosis could cause CAN memory to be erased.
1. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
2. If necessary, turn on the ignition switch.
3. Touch "START (NISSAN BASED VHCL)" or "System Shortcut" (eg: Engine) on the screen.
CONSULT-II Data Link Connector (DLC) Circuit
INSPECTION PROCEDURE
If the CONSULT-II cannot diagnose the system properly, check the given items.
NOTE: The DDL1 and DDL2 circuits from DLC pins 12, 13, 14 and 15 may be connected to more than one system. A short in a DDL circuit connected
to a control unit in one system may affect CONSULT-II access to other systems.
Ground Inspection