QX56 AWD V8-5.6L (VK56DE) (2005)
Air Bag: Service and Repair
Removal and Installation
Driver Air Bag Module
DRIVER AIR BAG MODULE
Removal and Installation
REMOVAL
CAUTION:
-
Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a driver air bag direct-connect harness connector is
damaged, the spiral cable must be replaced.
-
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
-
When servicing the SRS, do not work from directly in front of air bag module.
1. Remove the left and right side lids and bolts.
2. Lift the driver air bag module from the steering wheel.
3. Disconnect the horn connector and air bag harness, then remove the driver air bag module.
-
For removal/installation of the direct-connect SRS connectors, refer to "Direct-connect SRS Component Connectors".
CAUTION:
-
When servicing the SRS, do not work from directly in front of air bag module.