QX56 AWD V8-5.6L (VK56DE) (2005)
Throttle Position Sensor: Testing and Inspection
Component Inspection
THROTTLE POSITION SENSOR
1. Reconnect all harness connectors disconnected.
2. Perform EC-90, "Throttle Valve Closed Position Learning". See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Programming and Relearning/Throttle Valve Closed Position Learning
3. Turn ignition switch ON.
4. Set selector lever to D position.
5. Check voltage between ECM terminals 50 (TP sensor 1 signal), 69 (TP sensor 2 signal) and ground under the given conditions.
6. If NG, replace electric throttle control actuator and go to the next step.
7. Perform EC-90, "Throttle Valve Closed Position Learning". See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Programming and Relearning/Throttle Valve Closed Position Learning
8. Perform EC-91, "Idle Air Volume Learning". See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming
and Relearning/Idle Air Volume Learning