QX56 AWD V8-5.6L (VK56DE) (2005)
CAUTION:
^
Do not turn adjusting screw more than twice.
^
Replace steering gear assembly when adjusting screw is removed or more than twice.
4. Use a Tool to remove rear cover from sub-gear assembly.
Tool number: - (J-46213)
5. Remove O-ring with a flat-bladed screwdriver, and pull out rear cover.
6. Remove sub-gear assembly from gear housing assembly.
CAUTION: In order to protect oil seal from any damage, pull sub-gear assembly straight out.
7. Loosen lock nut of outer socket, and remove outer socket.
8. Remove boot clamps of the small diameter side and the large diameter side, then remove boot.
CAUTION: When removing boots, be careful not to damage inner socket and gear housing assembly. If they are damaged, replace them to avoid
fluid leaks.
9. Drill out the clinching part of cylinder outer rim with a 3 mm (0.12 inch) drill bit, drill to a depth of 1.5 mm (0.059 inch).
10. Remove end cover assembly with a 45 mm (1.77 inch) open head wrench or suitable tool.