QX56 AWD V8-5.6L (VK56DE) (2005)
CAUTION: The drive pinion nut is not reusable. Use a new drive pinion nut for installation.
5. Install the rear propeller shaft.
6. Connect the rear drive shafts to the rear final drive. Tighten the drive shaft inside flange bolts to specification.
Drive shaft inside flange bolt: 118 Nm (12 kg-m, 87 ft. lbs.)
7. Check the rear final drive fluid and add fluid as necessary.
Side Oil Seal
SIDE OIL SEAL
Removal and Installation
REMOVAL
1. Remove the drive shaft inside flange bolts to disconnect the rear drive shafts from the rear final drive. Support the rear drive shaft using a suitable
wire.
2. Remove the side flange using Tools as shown.
a. Install Tool "A" on the side flange.
Tool number A: KV40104100 ( - )
b. Pull the side flange out using Tool "B" as shown.
Tool number B: ST36230000 (J-25840-A)
Circlip installed position: Final drive side
3. Remove the side oil seal using a suitable tool as shown.
INSTALLATION
1. Apply multi-purpose grease to the sealing lips of the side oil seal
2. Press-fit the new side oil seal using Tool, until the front surface of the side oil seal is level with the end surface of the housing.
Tool number: ST35271000 ( - )